Verified 300-730 dumps Q&As - Pass Guarantee Exam Dumps Test Engine [2021]

300-730 dumps and 100 unique questions

There are no formal prerequisites for this certification exam, but the chances that you will pass it will be much higher if you fulfill the following criteria:

• Next, they should also have some experience managing and navigating firewalls and Cisco routers;
• For starters, it will be very beneficial for the candidates if they have a good understanding of the site-to-site and Remote Access VPN options;
• Lastly, the individuals should have some experience with different firewall and Cisco router command modes.

All in all, there are no strict requirements to fulfill, so you can whether have some prior experience to make things easier for you or can learn the exam content with great deliberation and try to master it to succeed. In any of these scenarios, your level of preparation and the skills you have gained will ultimately make a difference in your final result.

The associate exam 300-730 or Implementing Secure Solutions with Virtual Private Networks is linked to the CCNP Security certificate. It helps candidates to figure out how well they can implement secure remote communications with VPN solutions. Some of the areas tested in this exam include security for communication, architecture, and troubleshooting.

Cisco SVPN 300-730 Practice Test Questions, Cisco SVPN 300-730 Exam Practice Test Questions

The Cisco 300-730 exam is designed to measure the candidates’ knowledge and skills related to VPN solutions and implementation of secure remote communications. During the course of this test, the individuals will learn important skills, such as remote access VPN to create encrypted data, increase privacy, deploy and troubleshoot traditional Internet protocol security (IPsec), and more. This exam is associated with the Cisco CCNP Security certification.

NEW QUESTION 13
Refer to the exhibit.

Which type of VPN is being configured, based on the partial configuration snippet?

• A. GET VPN with dual group member
• B. FlexVPN load balancer
• C. GET VPN with COOP key server
• D. FlexVPN backup gateway

Answer: C

 

NEW QUESTION 14
An engineer is troubleshooting a new DMVPN setup on a Cisco IOS router. After the show crypto isakmp sa command is issued, a response is returned of "MM_NO_STATE." Why does this failure occur?

• A. The ISAKMP policy priority values are invalid.
• B. Tunnel protection is not applied to the DMVPN tunnel.
• C. ESP traffic is being dropped.
• D. The Phase 1 policy does not match on both devices.

Answer: C

Explanation:
Section: Troubleshooting using ASDM and CLI

 

NEW QUESTION 15
An engineer would like Cisco AnyConnect users to be able to reach servers within the 10.10.0.0/16 subnet while all other traffic is sent out to the Internet. Which IPsec configuration accomplishes this task?

• A. Option D
• B. Option A
• C. Option C
• D. Option B

Answer: D

 

NEW QUESTION 16
A Cisco ASA is configured in active/standby mode. What is needed to ensure that Cisco AnyConnect users can connect after a failover event?

• A. AnyConnect images must be uploaded to both failover ASA devices.
• B. AnyConnect client must point to the standby IP address.
• C. Configure a backup server in the XML profile.
• D. The vpnsession-db must be cleared manually.

Answer: A

Explanation:
Section: Secure Communications Architectures
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/ ha_active_standby.html

 

NEW QUESTION 17
What uses an Elliptic Curve key exchange algorithm?

• A. ECDHE
• B. SHA
• C. AES-GCM
• D. ECDSA

Answer: A

 

NEW QUESTION 18
After a user configures a connection profile with a bookmark list and tests the clientless SSLVPN connection, all of the bookmarks are grayed out. What must be done to correct this behavior?

• A. Specify the correct port for the web server under the bookmark.
• B. Verify HTTP/HTTPS connectivity between the Cisco ASA and the web server.
• C. Apply the bookmark to the correct group policy.
• D. Configure a DNS server on the Cisco ASA and verify it has a record for the web server.

Answer: D

 

NEW QUESTION 19
A network engineer has been tasked with configuring SSL VPN to provide remote users with access to the corporate network. Traffic destined to the enterprise IP range should go through the tunnel, and all other traffic should go directly to the Internet. Which feature should be configured to achieve this?

• A. hairpinning
• B. dual-homing
• C. U-turning
• D. split-tunnel

Answer: D

 

NEW QUESTION 20
Refer to the exhibit.

Which type of mismatch is causing the problem with the IPsec VPN tunnel?

• A. transform set
• B. Phase 1 policy
• C. crypto access list
• D. preshared key

Answer: D

 

NEW QUESTION 21
Refer to the exhibit.

The DMVPN tunnel is dropping randomly and no tunnel protection is configured. Which spoke configuration mitigates tunnel drops?

• A. Option D
• B. Option B
• C. Option A
• D. Option C

Answer: A

 

NEW QUESTION 22
Which statement about GETVPN is true?

• A. The pseudotime that is used for replay checking is synchronized via NTP.
• B. The configuration that defines which traffic to encrypt originates from the key server.
• C. TEK rekeys can be load-balanced between two key servers operating in COOP.
• D. Group members must acknowledge all KEK and TEK rekeys, regardless of configuration.

Answer: B

 

NEW QUESTION 23
Which command is used to troubleshoot an IPv6 FlexVPN spoke-to-hub connectivity failure?

• A. show crypto gkm
• B. show crypto identity
• C. show crypto ikev2 sa
• D. show crypto isakmp sa

Answer: C

Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/security/flexvpn/116413-configure-flexvpn-00.pdf

 

NEW QUESTION 24

Refer to the exhibit. A site-to-site tunnel between two sites is not coming up. Based on the debugs, what is the cause of this issue?

• A. An authentication failure occurs on the remote peer.
• B. A certificate fragmentation issue occurs between both sides.
• C. An authentication failure occurs on the router.
• D. UDP 4500 traffic from the peer does not reach the router.

Answer: D

Explanation:
Section: Troubleshooting using ASDM and CLI

 

NEW QUESTION 25
A second set of traffic selectors is negotiated between two peers using IKEv2. Which IKEv2 packet will contain details of the exchange?

• A. IKEv2 INFORMATIONAL
• B. IKEv2 IKE_AUTH
• C. IKEv2 IKE_SA_INIT
• D. IKEv2 CREATE_CHILD_SA

Answer: A

 

NEW QUESTION 26
Which two statements about the Cisco ASA Clientless SSL VPN solution are true? (Choose two.)

• A. When a client connects to the Cisco ASA WebVPN portal and tries to access HTTP resources through the URL bar, the client uses the local DNS to perform FQDN resolution.
• B. Clientless SSLVPN provides Layer 3 connectivity into the secured network.
• C. When a client connects to the Cisco ASA WebVPN portal and tries to access HTTP resources through the URL bar, the ASA uses its configured DNS servers to perform FQDN resolution.
• D. The rewriter enable command under the global webvpn configuration enables the rewriter functionality because that feature is disabled by default.
• E. A Cisco ASA can simultaneously allow Clientless SSL VPN sessions and AnyConnect client sessions.

Answer: C,E

 

NEW QUESTION 27
Which two types of web resources or protocols are enabled by default on the Cisco ASA Clientless SSL VPN portal? (Choose two.)

• A. RDP
• B. VNC
• C. ICA (Citrix)
• D. CIFS
• E. HTTP

Answer: A,D

Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/vpn/asa-94-vpn-config/ webvpn-configure-gateway.html

 

NEW QUESTION 28

Refer to the exhibit. Which type of mismatch is causing the problem with the IPsec VPN tunnel?

• A. transform set
• B. Phase 1 policy
• C. crypto access list
• D. preshared key

Answer: D

Explanation:
Section: Troubleshooting using ASDM and CLI
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/5409- ipsec-debug-00.html#ike

 

NEW QUESTION 29
Cisco AnyConnect Secure Mobility Client has been configured to use IKEv2 for one group of users and SSL for another group. When the administrator configures a new AnyConnect release on the Cisco ASA, the IKEv2 users cannot download it automatically when they connect. What might be the problem?

• A. Client services are not enabled.
• B. Client software updates are not supported with IKEv2.
• C. The new client image does not use the same major release as the current one.
• D. The XML profile is not configured correctly for the affected users.

Answer: A

 

NEW QUESTION 30
Refer to the exhibit.

The customer can establish a Cisco AnyConnect connection without using an XML profile. When the host "ikev2" is selected in the AnyConnect drop down, the connection fails. What is the cause of this issue?

• A. The HostName is incorrect.
• B. Primary protocol should be SSL.
• C. UserGroup must match connection profile.
• D. The IP address is incorrect.

Answer: C

 

NEW QUESTION 31
Which Cisco AnyConnect component ensures that devices in a specific internal subnet are only accessible using port 443?

• A. routing
• B. VPN filter
• C. WebACL
• D. split tunnel

Answer: B

 

NEW QUESTION 32
While troubleshooting, an engineer finds that the show crypto isakmp sa command indicates that the last state of the tunnel is MM_KEY_EXCH. What is the next step that should be taken to resolve this issue?

• A. Confirm that the pre-shared keys match on both devices.
• B. Ensure that UDP 500 is not being blocked between the devices.
• C. Correct the peer's IP address on the crypto map.
• D. Verify that the ISAKMP proposals match.

Answer: C

 

NEW QUESTION 33
Which parameter is initially used to elect the primary key server from a group of key servers?

• A. lowest IP address
• B. highest-priority value
• C. code version
• D. highest IP address

Answer: B

 

NEW QUESTION 34
Which parameter is initially used to elect the primary key server from a group of key servers?

• A. lowest IP address
• B. highest-priority value
• C. code version
• D. highest IP address

Answer: B

Explanation:
Section: Secure Communications Architectures
Explanation/Reference: https://www.cisco.com/c/en/us/products/collateral/security/group-encrypted-transport-vpn/ deployment_guide_c07_554713.html

 

NEW QUESTION 35
Under which section must a bookmark or URL list be configured on a Cisco ASA to be available for clientless SSLVPN users?

• A. tunnel-group (general-attributes)
• B. webvpn (global configuration)
• C. webvpn (group-policy)
• D. tunnel-group (webvpn-attributes)

Answer: B

Explanation:
Section: Remote access VPNs

 

NEW QUESTION 36
......

300-730 Dumps for Pass Guaranteed - Pass 300-730 Exam: https://www.validexam.com/300-730-latest-dumps.html

300-730 Exam Dumps - Try Best 300-730 Exam Questions: https://drive.google.com/open?id=1XROuwqicJieW6miNGGUvxVPfpZDIjA9Z